Information technology. Sensor networks. Guidelines for design in the aeronautics industry: active air-flow control1 Scope This document describes the concepts, issues, objectives, and requirements for the design of an active air flow control (AFC) system for commercial aircraft based on a dense deployment of wired wireless sensor and actuator networks. The objective of this AFC system is to track gradients of pressure across the surface of the fuselage of aircraft. This collected information will be used to activate a set of actuators that will attempt to reduce

Appliances for medical purposes (BS EN 60601)

The test method described in BS EN 61290-10-4 is called interpolated source subtraction (ISS) because the amplified spontaneous emission (ASE) at each channel is obtained by interpolating from measurements at a small wavelength offset around each channel

What is BS EN 6031-Aerospace series: Fibre reinforced plastics about

the transmission of scattered radiation and the transmission of total radiation is modified and references to IEC 61267 are omitted

Electro-pneumatic pressure control valves

you can enhance the efficacy of metallic ring joint gaskets for use with steel flanges and manufacture a standardized product that has global acceptance in the market

2 Flow rate as a function of inlet pressure

The specifications cover structures travelling vertically between two predefined levels along a guided path where the inclination to the vertical does not exceed 15° and supported or sustained by wire ropes

as well as in the event of foreseeable faults or malfunctions

The standard can reduce risk for organizations

BS 7317-6 on copper cathode applies to:

BS EN 61515 also gives recommendations to suppliers with respect to insulation composition